"When you give someone a book, you don't give him just paper, ink, and glue. You give him the possibility of a whole new life."
~Christopher Morely~
Here is the finished bookcase! The old book pages gave this project new life...
The two were married (see previous posts here and here) and the yucky backs were primed and then papered with a variety of old book pages and sheet music. I thought I would show you a quick how~to of doing this as well as the process I am using to revamp the inside of the trunk.
YOU WILL NEED:
*Wallpaper paste
*Sponge brush
*Old credit or gift card ~ to use as a smoothing tool
*Variety of old book pages that vary is size
*Old sheet music
*Paint brush
*Non~yellowing clear sealer
INSTRUCTIONS:
NOTE: If the surface you are covering is soiled you may want to prime it so that any stains will not bleed through your book pages once they are adhered.
*Lay book page face down on a protected surface, using sponge brush, brush a thin layer of glue over the whole page, making sure to get the edges.
*Place book page on surface and use old credit card or gift card to smooth out the paper, being careful no to put too much pressure or the paper will tear. You want to get out any air bubbles or wrinkles.
*Repeat this process with randomly placed pages mixed with sheet music until you cover your entire surface. Turn some pages sideways or upside down to get a more interesting look. You want to avoid to many straight edges lined up. If this occurs, just layer another page over the surface. You can even place some pages on an angle, there is no right or wrong way to do this. I even cut some pages in half and added them to the some of the edges.
*Allow to dry overnight
*Brush on a coat or two of non~yellowing clear sealer to protect your book pages, allowing to dry between applications.
Below are step~by~step progression photos of the process I used on my bookcase. I tend to do things the hard way, I didn't think of taking photos until I got the last shelf, yep, the one on the bottom. If the photo angles are a little strange or the lighting bad it is because I had to lay flat on my stomach on the floor to take them. Oh the things we will do in the name of blogging!
The trunk got gussied up with a few book pages on the exterior using the same process as described above.
Again, if your surface is stained, you will want to prime out your project or the stains will leach through your finish project. I primed all the interior surfaces not only due to stains but stink as well. I tried every remedy known to man and could not get the smell out of this trunk so I got a stain and odor blocking primer to treat the surface.
*To begin the project, tear the brown wrapping paper into pieces. You want a variety of sizes from a small, medium, to large range, the largest being no more than approx. 4 in. in size. Tear randomly not in straight pieces.
*Using the same gluing method as above, begin to randomly place the glued paper pieces on the surface of your project, over lapping the edges and smoothing out air bubbles as you go. You want to avoid any of the straight edges of the paper showing so always cover them up with a jagged edge overlapping them.
*Once your surface is covered, allow to dry overnight.
*Seal surface with one or two coats of sealer.
OPTIONAL: If you want a deep rich antique leather look, use and antiquing gel in a brown tone, found at most craft and hobby stores, before sealing. Apply the gel with a soft rag rubbing until you get the look you want. Allow to dry overnight before sealing. This technique looks fantastic on a wall or a tabletop for a leather looking surface.
Below are some photos of the steps in the process. If you see any shiny or white areas, this is the paste, I took these before it was dry.
*Standard shipping tags ~ We used medium and small tags in a cream color, white will work too
*1 1/2 cups boiling water
*2 Moroccan Pomegranate Red tea bags ~ Celestial Seasonings is the brand we used
*6 drops red food coloring
*3 Tablespoons strawberry flavoring ~ found in the baking section of the grocery store
*Cookie cooling racks
*Shallow container ~ I use and old casserole dish
*Old Cookie sheet ~ be sure it is not rusty, if it is, cover it with aluminum foil
*250 degree preheated oven
TO MAKE TAGS:
*Pour boiling water into shallow dish and steep tea bags in boiling water for several minutes, stirring occasionally to distribute colored tea.
*Add food coloring and strawberry flavoring, stir.
*Place tags in liquid mixture and allow to soak for 20 seconds or so until they reach the desired depth of color of your choice.
*Remove tags from liquid and place on old baking pan in a single layer, make sure pan is not rusty or the rust will transfer to the tag and stain it.
*Place baking sheet in preheated oven and bake for 3 minutes, remove from oven, turn over tags, replace in oven for 3 more minutes. Tags are dry when they begin to curl. DO NOT LEAVE TAGS UNATTENDED!
*Cool tags on cookie cooling racks.
*Once completely dry and cool, store tags in a sealed container or zip storage bag until use. This will preserve the scent of the tag.
*Remove tags from storage and embellish any way you wish and enjoy!
*For trims, soak in liquid mixture until desired color is reached. Gently squeeze out excess liquid. Lay trim out on a flat surface covered with waxed paper and paper towels and allow to dry. I put some paper under some of mine instead of paper towels and it left the dye residue on the paper staining it, which will make a really cool background paper.
I am working on some other scented tag experiments, I'll let you know how they turn out. I am thinking peppermint for Christmas!
Well, I have not quite come unglued yet, I still have to tackle the inside of the trunk bottom before I can get to the old door project. Aren't the possibilities of a whole new life by the addition of a little paper and glue delicious?
Blessings,
Sandy